We are at the last chapters of the CCNA Data Center 640-911 by Todd Lammle. Chapter 12 talks about redundant switched technologies and chapter 13 talks about security. Just like before I will go over the high-points, so let’s get started! Chapter 12 Overview: In this chapter we get to learn about Spanning Tree Protocol …

Read More

Just like before if you have followed, I have gone over the CCNA Data Center Study Guide from Todd Lammle and in this post we cover two chapters. Feel free to comment below if you have any questions on either of these two chapters. Chapter 10 Overview: Chapter 10 starts us back in the book, before we do any configuring …

Read More

Back where we left off, if you have followed I have gone over the CCNA Data Center Study Guide from Todd Lammle and in this post we will cover two chapters 8 and 9. Comment below if you have any questions on these two chapters let's get started. Chapter 8 Overview: We are actually making some progress, we configure the …

Read More

I previously had the chance to play around with the 5596UP switch, and made some notes on how to configure inter-vlan routing. Since this was a 5596UP switch I needed a layer 3 card to take advantage of it. The next-generation units the 5600 include layer 3 without a card required along with introducing 40GB uplinks! …

Read More

If you made it past the earlier chapters this one should be interesting, like before I am going through each chapter of the CCNA Data Center Study Guide from Todd Lammle. Comment below if you have questions in this chapter, last week we learned about subnetting and in this chapter we will learn about the NX-OS which is …

Read More